# Drag outward from this point to define the desired length and angle of the base side. Left-click a second time to define the base.
# To establish the height, drag the mouse away from the base to the desired location. Left-click a third time to complete the Taper Strip.
Â
NOTES, SPECIAL CASES OR EXCEPTIONS: '''Taper Length''' establishes the distance between the base and top sides of the trapezoid. If the '''Exponential''' check box is checked, the two slanted sides of the trapezoid are replaced by exponential curves passing through the same vertices.
DIALOG PROPERTIES
'''Base Length''' defines the length of the taper strip's base. '''Top Length''' defines the length of the taper strip's top. '''Height''' establishes the distance between the base and top curves. '''Exponential''' creates blended or curved sidewalls rather than linear sidewalls. This option is off by default.
[[File:cad_surf6.png]]